Prefer Primary SIP Server to No or Yes depending on your configuration. Set to No if no Failover SIP Server is
defined. If “Yes”, account will register to Primary SIP Server when failover registration expires.
Outbound Proxy with your Outbound Proxy IP Address or FQDN. Leave empty if not available.
4. Press Save and Apply to save your configuration.
Figure 17: SIP Settings
5. Go to DECT 🡪SIP Account Settings
6. Configure your SIP details in desired account:
Account: Select Account row to configure (Account 1 – Account 10).
SIP User ID: User account information, provided by VoIP service provider (ITSP). Usually in the form of digit similar to
phone number or actually a phone number.
Authenticate ID: SIP service subscriber’s Authenticate ID used for authentication. Can be identical to or different from SIP
User ID.
Password: SIP service subscriber’s account password to register to SIP server of ITSP. For security reasons, the password
will field will be shown as empty.
Name: Any name to identify this specific user.
Profile: Select the corresponding Profile ID (1/2/3/4).
HS Mode: Assign the account to specific Handsets (HS1, HS2…) or hunting group mode.
Active: Set to Yes. If set to No, account is disabled and will not register.
7. Press Save and Apply to save your configuration.
Figure 18: SIP Accounts Settings
To Next Page
Loading...
Need help?
General
