Grandstream Networks GXV33 Series Administration Guide

GXV3370 Administration Guide
Version 1.0.1.12
P a g e | 54
TURN Server Password
Fill in the password to validate TURN server.
Use NAT IP
Configures the IP address for the Contact header and Connection
Information in the SIP/SDP message. It should ONLY be used if it’s
required by your ITSP. The default setting is keep the box blank.
Phone Settings/Call Settings
Call Features
Disable Video Call
Feature
Disables the video call feature on the phone. The default setting is “No”.
Use Quick IP-Call mode
Sets the phone system to automatically fills in the first three octets to make
an outbound IP call. If it is set to “Yes”, users can dial an IP address under
the same LAN/VPN segment by entering the last octet in the IP address.
To dial quick IP call, offhook the phone and dial #XXX (X is 0-9 and XXX
<=255), the phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is “No”.
Disable Call-Waiting
Disables the call waiting feature. If it is checked, the phone system will
reject the second incoming call during an active session without user’s
knowledge. But this missed call record will be saved to remind users. The
default setting is “No”.
Disable Call-Waiting
Tone
Sets the phone system to play the call waiting tone if there is another
incoming call. If it is set to “Yes”, the phone will only display the indicator
on the LCD screen for another incoming call. The default setting is “No”.
Disable DND Reminder
Ring
Configures the phone system will play the DND reminder ringtone for the
incoming call if the DND feature is enabled. If it set to “Yes”, the phone will
keep mute instead of playing a ring splash to indicate an incoming call
when DND is enabled. The default setting is “No”.
Disable Transfer
Disables the transfer feature. When set to “Yes”, the phone system will
block the TRANSFER key on the LCD screen. The default setting is “No”.
Hold Call Before
Completing Transfer
When set to "Yes" the phone holds the second call before completing the
attended transfer (it sends the INVITE method to hold the call before
sending the REFER method).
Default Transfer Mode
Sets the default transfer mode for the phone system. If the Blind Transfer
or Attended Transfer mode is set, the phone system will use the specific
mode to transfer an active call. The users still have privilege to switch the
mode on the LCD screen when they tap the transfer key. The default setting
is “Blind Transfer”.

Grandstream Networks GXV33 Series Specifications

General

Brand	Grandstream Networks
Model	GXV33 Series
Category	IP Phone
Language	English