Grandstream Networks GXV33 Series Administration Guide

GXV3370 Administration Guide
Version 1.0.1.12
P a g e | 55
Enable Function for
Incoming Call
Enables the preview feature for the incoming video calls. Defines the
function for the incoming video call. If it is set to “Preview”, the phone
system will pop up the PREVIEW key on the LCD screen when there is an
incoming video call, and users could tap on it to check video caller without
answering the incoming video call (the call will keep playing ringback on
the caller side). The default setting is “None”.
Note: By pressing the preview button, the phone will send the SIP 183
message to the caller’s camera, based on SIP RFC3261; the caller’s
camera should start sending the stream to the phone upon receiving the
SIP 183.
At any time, the GXV3370 user can press the "Answer" button. If done,
then the phone will send the SIP 200OK and call will be fully established.
Disable Conference
Disables the conference. When set to “Yes”, the phone will block the
conference application. The default setting is “No”.
Auto Conference
Allows the phone system to invite all call parties into a conference by
pressing the Conf key. If it is disabled, the end user has to add each call
party to conference manually. The default setting is “No”.
Auto Mute on Entry
Configures whether to mute the call on entry automatically.
• If set to "Disable", then do not use auto mute function.
• If set to "Auto Mute on Outgoing Call", then mute automatically
when the other party answers the outgoing call.
• If set to "Auto Mute on Incoming Call", then mute automatically
when answers the incoming call; If set to "Mute on Incoming &
Outgoing Call", then mute automatically when the call gets through.
Note: This function only take effect when the phone is from the idle status
to call status. Users could click the Mute button on call interface to cancel
the current mute status.
Personalization
Always Ring Speaker
Determines if the speaker will play the ringtone if the speaker channel is
not set as default channel. If set to “Yes”, the phone will force to play the
ring speaker in speaker channel. The default setting is “No”.
End user might need this feature when the headset is connected.
Offhook Auto Dial
Configures the User ID/extension to dial automatically when the phone is
off-hook. The phone will use the first account to dial the configured
numbers out. The default setting is “No”.
Offhook Auto Dial Delay
(s)
Defines the timer for warm line dialing. After the timer expires, the phone
system will dial the configured number in Off-hook Auto Dial automatically.
If it is not configured, the configured number will be dialed immediately.
Offhook/OnHook
Timeout (s)
If configured, the phone will exit the dial-up screen when timeout after
Offhook or Onhook. default is 30s. The valid range is 10-60s.

Grandstream Networks GXV33 Series Specifications

General

Brand	Grandstream Networks
Model	GXV33 Series
Category	IP Phone
Language	English