15
Speed Screen
The speed feature sets the speed mode of machine. 1 is low speed; 2 is high
speed. Press Enter to save selection for the current run. Note: The default
state is low. When the machine is restarted, the PT 331SCC will default to the
slow speed.
Crease + Slit Screen
The normal function of the PT 331SCC is to leave the slit motor off when
performing crease only jobs or jobs that do not require the function of the
slitters.
If the required job is jamming at the slitters, turning on this function will allow the slitters to rotate and feed the
paper through. To turn on the slit motor, select 1, turn off the slit motor, select 2. Press Enter to save changes.
Note: The default state is off. When the machine is restarted, the PT 331SCC will default to slit motor off.
To Next Page
Loading...
