GRAPHTEC FC5100-130 - Page 145

Setting the Interface Functions: STEP SIZE - Setting the Programmable Resolution
144
NOTE: Be sure to set the step size to match the step size setting of your software
application.
NOTE: Your step size setting is retained in the plotter’s internal memory even while the
plotter is turned off.
• Press the F2 key to select STEP SIZE.
• Press the F1 key to select 0.100, press the F2 key to select 0.050, press the F3
key to select 0.025, or press the F4 key to select 0.010.
• Press the Enter key to register your setting and return to the INTERFACE menu.
STEP SIZE>*
RS-232C>*
COMMAND>*
STEP SIZE.......0.100>*
IN mm.........0.050>*
0.025>*
0.010>*
STEP SIZE>*
RS-232C>*
COMMAND>*