Options: FC5100 Auto Registration Mark Sensor
179
• The value representing the distance between registration mark 1 and mark 2 is
stored in the X-axis. The value representing the distance between registration
mark 1 and mark 3 is stored in the Y-axis.
Note: If you select the 2-POINTS method, the Y-axis information is ignored.
Note: After the plotter senses the first registration mark, it discontinues sensing,
moves to the specified distance and starts searching for the next registration
mark.
Note: If the distance is set at 0mm, the plotter moves slowly searching for the next
registration mark.
Note: Always enter a distance value that is shorter than the actual distance between
the registration marks. The plotter will move to the new location and start
searching for the registration mark. If the sensor starts searching after it
passes the registration mark, the sensor will not locate the registration mark.
Caution: If you set the distance of the X-axis to longer than the length of the media, the
plotter will move the required distance and the media will fall off of the plotter.
• Press the ENTER key to register your setting.
• The following menu appears. If you wish to set another parameter, press the key
corresponding to that setting.
• Press the MENU key to cancel menu mode when all of the parameters are set.
Selecting the
Registration
MARK TYPE
The MARK TYPE function is used to select the registration mark pattern. There
are two types of registration patterns that the plotter can sense, pattern 1 and pat-
tern 2.
• Press the MENU key to select MENU mode.
• Press the NEXT key.
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
Mark 1
Mark 2
Pattern 2
Mark 2
Pattern 1
Y
Mark 3 Mark 1
Y
X
Mark 3
Media feed
direction
Enter distance X to the "X=", distance Y to the "Y=".
X
To Next Page
Loading...