Options: FC5100 Auto Registration Mark Sensor
191
• Load pre-printed media into the plotter. Make sure that the pinch roller is set
outside of the registration mark. If you wish to use the auto-scanning mode, set
the pinch roller to just outside of the registration mark.
• The following menu appears:
Press the POSITION key to move the pen and media to the area necessary for
scanning the first registration mark. When using AUTO scan mode, move the
media to the first registration mark that is located between the pinch roller and the
pen.
When using MANUAL scan mode, move the pen and the media to the square
area that is created by the first registration mark.
AUTO REG. MARK *
AUTO>*
MANUAL>*
Left pinch
roller
Right pinch
roller
Mark 1Mark 3
Mark 2
Mark 3
Mark 1
The pen moves
on this line.
Media feed
direction
The pen moves
on this line.
Left pinch
roller
Right pinch
roller
Mark 2
Pattern 1 Pattern 2
Mark 2
Left pinch
roller
Right pinch
roller
Media feed
direction
Move the pen
into this area.
Pattern 1
Mark 1
Mark 3
Move the pen
into this area.
Pattern 2
Mark 1
Mark 3
Mark 2
Right pinch
roller
Left pinch
roller
To Next Page
Loading...