Options: FC5100 Two-Pen Option
195
Attaching a Writ-
ing Pen to the
Pen Station
The pen station is mounted on the right side of the cutter. Follow the procedure
below to attach a cutter pen to the pen station:
CAUTION: You must attach only writing pens to the pen station. Writing pens can be
either fiber tip, ballpoint, ceramic tip, or ink. Do not attach any cutting blades to
the pen station; PEN 2 is held on by a magnet and cannot hold up to the high
force required for cutting.
CAUTION: The cutter must be prop-
erly seated (the pen holder
is engaged on the flange)
before tightening the
screw.
Flange
Bracket to hold pen
1 Open the pen-hold mechanism
on the pen station.
2 Attach the pen to the pen sta-
tion. Make sure the bracket of
the pen station is engaged to
the upper groove on the pen.
Fit the bracket into the upper groove
To Next Page
Loading...