Options: FC5100 Two-Pen Option
197
• Press the F4 key to select OPTION 2.
• Press the F1 key to select PEN OFFSET ADJ.
• Press the POSITION key to move the pen into position to plot the first cross
mark. Press the F3 key to select TEST PATTERN.
The plotter plots the first cross mark using PEN 1, then plots the second cross
mark using PEN 2.
You must measure the distance between the first plotted cross mark and the
second plotted cross mark on both the X and Y-axis.
If the two cross marks match,
set 00.0mm on both the X and Y-axis or
press the NEXT key to cancel this mode.
If the location of the cross marks do not match, change the PARAMETER SET.
*
BACKGROUND SETTINGS>*
OPTION 1>*
OPTION 2>*
PEN OFFSET ADJ.>*
INITIAL DOWN FORCE>*
DISTANCE ADJUST>*
TEST>*
PEN 1-2 OFFSET
ADJUST
TEST PATTERN>*
PARAMETER SET>*
Current pen position
Second cross mark
plotted by the PEN 2
on the pen station
X
Y
-Y
-X
+Y
Axis direction
Media feed
direction
+X
First cross mark
printed by the PEN 1
on the pen carriage
To Next Page
Loading...