GRAPHTEC FC5100-130 - Page 53

Preparing to Cut: Setting Conditions
52
• Press the UP or DOWN ARROW key to raise or lower the numeric value 1 to 40.
• If you wish to change another parameter then:
• Press the F2 key to change SPEED.
• Press the F3 key to change QUALITY.
• Press the F4 key to change OFFSET.
• If all of the parameters are set press the ENTER key to register your setting.
TO CHANGE THE CUTTER SPEED
• Press the F2 key to change SPEED. The blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 100. [1 to 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, 100]
• If you wish to change another parameter then:
• Press the F1 key to change FORCE.
• Press the F3 key to change QUALITY.
• Press the F4 key to change OFFSET.
• If all of the parameters are set press the ENTER key to register your setting.
TO CHANGE THE CUTTER QUALITY
• Press the F3 key to change QUALITY. The blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 8. The smaller the value, the higher the quality. When you select a speed that
is faster than 60, you cannot select quality. At that time an “xx” appears.
• If you wish to change another parameter then:
• Press the F1 key to change FORCE.
• Press the F2 key to change SPEED.
• Press the F4 key to change OFFSET.
SET............14
CONDITION 1........30
4
CB09Ux...0
SET............14
CONDITION 1........30
4
CB09Ux...0