GRAPHTEC FC5100-130 - Page 58

Preparing to Cut: Setting Conditions
57
NOTE: Press the NEXT key to cancel the condition that you are currently setting and
return to the main menu.
TO CHANGE THE PEN FORCE
• Press the F1 key to change FORCE. A blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 40.
• If you wish to change another parameter then:
• Press the F2 key to change SPEED.
• Press the F3 key to change QUALITY.
• If all of the parameters are set press the ENTER key to register your setting.
TO CHANGE THE PEN SPEED
• Press the F2 key to change SPEED. A blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 100. [1 to 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, 100.]
• If you wish to change another parameter then:
• Press the F1 key to change FORCE.
• Press the F3 key to change QUALITY.
• If all of the parameters are set press the ENTER key to register your setting.
SET............14
CONDITION 2........60
4
PEN.....
SET............14
CONDITION 2........60
4
PEN.....