Preparing to Cut: Changing Feed Speed
62
• Press the F4 key to set parameters such as STEP SIZE, RS232C CONDITIONS
AND COMMANDS. For details see Setting the Interface Conditions.
• Raise the media set lever to engage the media. The media type menu appears
on the display; press the key which corresponds to the type of media that is
loaded for cutting/plotting.
• Press the F1 key to select ROLL-1.
• Press the F2 key to select ROLL-2.
• Press the F3 key to select SHEET.
• Press the F4 key to select CONTINUE.
AUTO PRE FEED>.
INITIAL FEED SPEED>.
INTERFACE>.
ROLL-1>.
ROLL-2>.
SHEET>.
CONTINUE>.
To Next Page
Loading...