Advanced Functions and Settings: AREA - Setting the Cutting Area
75
both UR and LL positions), the message below appears for several seconds.
In this case, reset the effective cutting area.
NOTE: When the ROTATE and MIRROR mode is selected or canceled after specifying
new LL and UR positions, your LL and UR settings are initialized to their
default positions.
NOTE: The effective cutting area cannot be specified past the origin in the direction of
media feeding.
When the origin is set as shown in the example below, the shaded area repre-
sents the effective cutting area defined by the LL and UR points.
When the ROTATE mode has been selected to rotate the coordinate axes by 90°
as shown in the example, the shaded area represents the effective cutting area
defined by the LL and UR points.
ILLEGAL PLOT AREA
To Next Page
Loading...