GRAPHTEC FC5100-130 - Page 78

Advanced Functions and Settings: EXPAND - Expanding the Cut Area
77
• Press the F3 key to select EXPAND. (ORIGIN in the 1
st
row appears in HP-GP
mode only.)
• Press the UP or DOWN ARROW key to select the value.
• Press the F4 key to select DEFAULT (0), if you wish to return to the original cut-
ting area.
• Press the ENTER key to store your setting, the following menu will appear:
If the F4 key is pressed, return to the previous menu.
• Press the F3 key to select CONTINUE or press the F4 key to select CANCEL.
If CONTINUE is selected, the MEDIA TYPE MENU will appear. Select the
media type you wish to use.
• Press the F1 key to select ROLL-1, press the F2 key to select ROLL-2 or press
the F3 key to select SHEET.
If CANCEL is selected, return to the previous menu. Press the MENU key to
cancel MENU mode.
ORIGIN>.
AREA>.
EXPAND>.
PAGE LENGTH>.
SET EXPAND LIMIT
0 mm
DEFAULT>.
THIS OPERATION
RESETS THE PLOTTER !
CONTINUE>.
CANCEL>.
ROLL-1>.
ROLL-2>.
SHEET>.
ORIGIN>.
AREA>.
EXPAND>.
PAGE LENGTH>.