Advanced Functions and Settings: AXIS ALIGNMENT - Axis Alignment Parameter Setting
87
individually, as with the 2-point method, and you may match the plotter’s distance
scale to that of the printed image.
To match the plotter’s distance scale to that of the printed image, the distance
between points 1 and 2, and points 1 and 3 must be known. This function helps
when the dimensions of the printed image change during printing, laminating or
storage.
• AXIS POINT 1: Registration mark. In both the two and three-point methods, this
point is commonly used as the reference for X and/or Y axis alignment.
• AXIS POINT 2: Registration mark or any point on the line which goes through
AXIS POINT 1 and along the X axis of the pre-printed image.
• AXIS POINT 3: Registration mark or any point on the line which goes through
AXIS POINT 1 and along the Y axis of the pre-printed image. This is only avail-
able when the three-point method is selected.
• AXIS ORIGIN POINT: Origin point of pre-printed image.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
• Press the F4 key to select FUNCTION 2.
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.
To Next Page
Loading...