Advanced Functions and Settings: AUTO PRE-FEED - Advancing the Media Automatically
92
The FEED LENGTH can be set in a range of 1 to 50 meters. If the feed length is
set too high (too long), the media will unwind. Unwound media will not cut as eas-
ily as wound media.
• Press the ENTER key to register your settings or press the MENU key to cancel
MENU mode.
NOTE: The plotter begins pre-feeding as soon as the cutting data is sent from the PC
when the auto pre-feed is enabled AND the new origin point is within 50mm of
the previous feed’s border.
You may access the auto pre-feed menu from the initial menu which appears on
the LCD when the paper set lever is lowered.
• Press the F4 key to select the initial menu while the initial menu appears on the
LCD.
• Press the F2 key to select AUTO PRE-FEED.
• Press the F3 key to select ENABLED or press the F4 key to select DISABLED.
If the F3 key is pressed, the following menu will appear:
• Press the UP or DOWN ARROW to lengthen or shorten the FEED LENGTH. The
menu will cycle through the available lengths in sequence.
LOAD MEDIA!
INITIAL MENU>.
.
AUTO PRE FEED>.
INITIAL FEED SPEED>.
INTERFACE>.
AUTO PRE FEED
ENABLED*
DISABLED *
AUTO PRE FEED
FEED LENGTH= 1 m
To Next Page
Loading...