FC8600-UM-251-9370 7-9
7 ADJUSTMENT
How to adjust the middle push roller of push roller force
(1) Movethepinchrollertothespeciedadjustmentposition.
(2) Move the position for other push rollers from the grid roller which you are not going to adjust for the
push rollers now.
The other push rollers should not be positioned on the grid roller.
(3) Set the push roller force lever to the lower position for the high force.
(4) Loosen the screw (upper screw) holding the force adjustment bracket as shown in the picture below.
Loosen this screw.
(5) Measure the push roller force, and then adjust the push roller force by using the force adjustment screw
as shown in the picture below. (The push roller force should be 6.5 kg +-0.25 kg.)
Push roller force adjustment screw
Clockwise: Strong
Counterclockwise : Weak
(6) Spread the screw-lock-glue (1401B) to the adjustment screw after the push roller force was adjusted.
To Next Page
Loading...
