GRAPHTEC FC8600-160 - Setting Feeding Method

FC8600-UM-251-9370 6-15
6 DISASSEMBLY AND REASSEMBLY
6.2.6 How to Replace the Y-belt
How to detach the Y-belt
(1) Detach the right and left side covers (see Subsection 6.1.1 and Subsection 6.1.2).
(2) Detach the center cover (see Subsection 6.1.4).
(3) Detach the pen block (see Subsection 6.2.5).
(4) Loosen the two M3L35 binding head screws adjusting the Y-belt tension.
M3L35 binding head screw
(5) Remove the four M3L6 binding head screws attaching the right and left Y-belt stopper plates to the
slider.
Y belt
M3L6 binding head screw
(6) Detach the Y-belt from the unit.