GRAPHTEC FC8600-160 - Scan Range Necessary to Detect the Registration Mark

FC8600-UM-251-9370 8-9
8 TROUBLESHOOTING
8.4.4 Error Messages on ARMS
Error
code
Error Display Cause Solution
E04001
Tilt to adjust with AXIS
ALIGNMENT is too large.
Reload the media.
E04003
Failed to adjust the sensor
level.
This media cannot be used.
E04004
It is over the setting range of
the distance adjust.
Reset to smaller value.
E04005
Could not scan the registration
marks.
Check the registration scan position.
E04006
Amount of data has exceeded
the I/O buffer size for the
segment area registration
mark.
Decrease the data.
E04007
Test pattern plotting position is
not within the plotting area for
sensor position adjustment.
Move the media toward center and
plot the test pattern.
E04008
Media end was detected while
detecting the registration mark.
Check the media. Check the print
position of the registration mark.
E04009
It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04010
E04011
E04012