FC8600-UM-251-9370 18
8 TROUBLESHOOTING
8.5.4 Conrm the Cutting Data
Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the
transmission of cutting data is performed correctly.
Operation
(1) Set a media larger than A4 size.
(2) Set the pen tool to the tool carriage and select the condition where the pen tool is set.
(3) Press the [MENU] key to display the menu below.
(4) Press the POSITION (
t
) key (TEST) to display the menu below.
(5) Press the [3] key (DATA DUMP) to display the menu below.
(6) Con rm that the pen tool is set.
(7) Con rm that operation area of tool and media is safe.
(8) Press the [1] key (DONE).
(9) Output the data to plotter from the PC. The dump list starts when the plotter received the data.
To stop the dump list
(1) Quit outputting at the PC, and then turn off the power for the plotter.
To Next Page
Loading...
