GRAPHTEC FC8600-160 - Printing the Setting of the Plotter

FC8600-UM-251-9370 16
8 TROUBLESHOOTING
8.5.2 Printing the Setting of the Plotter
Condition setting list can be printed when you need to check the current setting of the plotter.
Operation
(1) Set a paper larger than A3 size.
(2) Set the pen tool to the tool carriage and select the condition where the pen tool is set.
(3) Press the [MENU] key to display the menu below.
(4) Press the POSITION (
t
) key (TEST) to display the menu below.
(5) Press the [1] key (CONDITION LIST) to display the menu below.
(6) Press the [1] key (DONE 1/2) or the [2] key (DONE 2/2).
Message to conrm tool position is displayed.
(7) Move the tool carriage to print start position by using the POSITION key.
(8) Press the ENTER key to start printing the condition list.
It will return to READY status when the printing is completed.