FC8600-UM-251-9370 2-3
2 PARTS NAMES and FUNCTIONS
2.2 Assembling
Assemble the stand�
Stand side bar x 2 Base assembly x 2 Center bar x 1 Allen wrench
(for M5 screws) x 1
Socket head cap screw
(M5) x 20
Media stocker x 2
Stock roller x 2
Front Loading and Rear Loading
It is necessary to set the loading settings from the plotter control panel depending on the attachment
direction�
Default factory setup is set as rear loading�
It is recommended to use as rear loading�
If you desire to load the material from the front, it is also possible to use the front loading�
Use the plotter with enough space behind in this case�
Also, be aware that continuous cutting with cross cut is not possible�
Assembling the Stand
The mounting direction is different for the front loading and the rear loading models�
<Front loading>
<Rear loading>
To Next Page
Loading...
