GRAPHTEC FC8600-160 - Adjusting the Offset of the Light Pointer Position

FC8600-UM-251-9370 7-30
7 ADJUSTMENT
7.3.10 Adjusting the Offset of the Light Pointer Position
If you replace the light pointer or the main board, you need to adjust the offset.
How to adjust the offset of the light pointer position
(1) Enter the adjustment menu (see Section 7.3.4).
(2) Load an A2 or larger size sheet of paper in the plotter.
(3) Mountabertippeninthepenholder.
(4) Press the UP arrow or Down arrow key until the menu shown below is displayed.
(5) Press the F1 key to display the menu shown below.
(6) PresstheF2keytoselectthebertippenthemenushownbelow.
(7) PresstheENTERkeytosetthebertippen.
(8) Press the UP arrow or Down arrow key until the menu shown below is displayed.
(9) Press the F1 key to display the menu shown below.