GRAPHTEC FC8600-160 - Clearing the Non-Volatile RAM

FC8600-UM-251-9370 7-16
7 ADJUSTMENT
7.3.3 Clearing the Non-Volatile RAM
When you replace the main board, you must clear the Non-Volatile RAM (NOV-RAM).
If you clear the Non-Volatile RAM, you will lose the setup parameters for each adjustment.
Input the adjustment values to the main board after you clear the Non-Volatile RAM.
How to clear the Non-Volatile RAM.
(1) Set SW1 to the NOV-RAM clear mode as shown below.
FC8600-60
SW1
12345678
ON
OFF
FC8600-75
SW1
12345678
ON
OFF
FC8600-100
SW1
12345678
ON
OFF
FC8600-130
SW1
12345678
ON
OFF
FC8600-160
SW1
12345678
ON
OFF
(2) Turn on the power to the plotter.
(3) The NOVRAM CLEAR START menu appears. The plotter immediately starts to clear the parameters on
the NOV-RAM, and then sets the default values.
NOVRAM CLEAR START
(4) When the programming is complete, the NOVRAM CLEAR COMPLETE menu appears.
(5) Turn off the power to the plotter.