FC8600-UM-251-9370 8-13
8 TROUBLESHOOTING
8.4.6 Warning Messages
Error
code
Error Display Cause Solution
W06001
Cross cut function cannot be
used for sheet media.
Use roll media.
W06002
Cross cut function cannot be
used because the media is
loaded from the front.
Load the media from the rear.
W06003
Cross cut function cannot be
used until the media size is
detected.
Load the media.
W06004
Cross cut function cannot be
used when the push roller
sensor is disabled.
Enable the push roller sensor.
W06005
Cross cut function cannot be
used when the media sensor is
disabled.
Enable the media sensor.
W06007
CONDITION No. that has
selected pouncing tool as the
tool number setting can only
set TOOL 1.
Select TOOL 1.
W06008
When command is set to
auto, the DUMP mode is not
available.
Select the command setting to the
HP-GL or the GP-GL.
W06009
When panel cutting is on, copy
and origin point settings cannot
be changed.
W06010
When the rotation is set to on,
data including registration mark
scan data cannot be copied.
W06011
When the mirror is set to on,
data including registration mark
scan data cannot be copied.
To Next Page
Loading...
