GRAPHTEC FC8600-160 - Adjusting the Offset of the Auto-Registration Mark Sensor

FC8600-UM-251-9370 7-26
7 ADJUSTMENT
7.3.8 Adjusting the Offset of the Auto-Registration Mark Sensor
If you replace the Auto-registration mark sensor or the main board, you need to adjust the offset.
How to adjust the auto-registration mark sensor
(1) Enter the adjustment menu (see Section 7.3.4).
(2) Load an A2 or larger size sheet of paper in the plotter. The paper color must be white, and it is
recommended that high-quality paper made for ink-jet printers be used.
(3) Mountabertippeninthepenholder.
(4) Press the UP arrow or Down arrow key until the menu shown below is displayed.
(5) Press the F1 key to display the menu shown below.
(6) PresstheF2keytoselectthebertippen.
(7) PresstheENTERkeytosetthebertippen.
(8) Press the UP arrow or Down arrow key until the menu shown below is displayed.
(9) Press the F1 key to display the menu shown below.