GRAPHTEC FC8600-160 - Page 87

FC8600-UM-251-9370 7-27
7 ADJUSTMENT
(10) Press the F1 key to display the menu shown below.
(11) Use the ARROW keys to move the pen to an open area to plot the adjustment pattern.
(12) Use the ARROW keys to move the pen to an open area to plot the adjustment pattern.
(13) Press the ENTER key to plot the adjustment pattern shown below.
Plotted target mark
Adjustment lines
(14) The plotter immediately adjusts the registration mark sensor position automatically, and adds a vertical
line and a horizontal line to the scanned plotted pattern.
(15) Measuretheoffsetbetweenthelinesandconrmthattheyarewithin0.25mm.
(16) Press the ENTER key to store the setting.
(17) Turn off the power to exit from the adjustment menu.