GRAPHTEC FC8600-160 - Adjusting the Spacing between Pen 1 and Pen 2 (2-Pen Model)

FC8600-UM-251-9370 7-36
7 ADJUSTMENT
7.3.13 Adjusting the Spacing Between Pen 1 and Pen 2 (2-pen model)
This adjustment will set the spacing between pen 1 and pen 2.
If you replace the main board, use the following procedure to input the recorded adjustment values.
If you replace the pen block, you must adjust this value using the following procedure.
(1) Enter the adjustment menu (see Section 7.3.4).
(2) Load an A2 or larger size sheet of paper in the plotter.
(3) Mountthebertippensinthe1-penholderand2-penstation.
(4) Press the UP arrow or Down arrow key until the menu shown below is displayed.
(5) Press the F1 key to display the menu shown below.
(6) PresstheF2keytoselectthebertippenthemenushownbelow.
(7) PresstheENTERkeytosetthebertippen.
(8) Press the UP arrow or Down arrow key until the menu shown below is displayed.
(9) Press the F1 key to display the menu shown below.