GRAPHTEC FC8600-160 - Pinch Roller Pressure Adjustment

FC8600-UM-251-9370 7-5
7 ADJUSTMENT
7.2.4 Pinch Roller Pressure Adjustment
How to measure the push roller force
(1) Detach the center cover (see Subsection 6.1.4).
(2) Change the hold-down force switching lever to the Strong position.
(3) Hang the wire as shown in the picture below, and then measure the force by using the push-pull gauge.
Hang the wire to the push roller shaft.
(4) The push roller force should be 6.5 kg +-0.25 kg
(5) Adjust the push roller force at locatin shown in the picture below.
Adjusting position for each push rollers
FC8600-60
FC8600-75
FC8600-100
FC8600-130
FC8600-160
Middle push rollers
Right push rollersLeft push rollers