FC8600-UM-251-9370 2-2
2 PARTS NAMES and FUNCTIONS
Rear View
Push roller hold-down force switching lever
Media set lever
Stock rollers
Media stocker
AC line inlet
USB interface
Media lock
RS-232C interface
Network interface (Factory-installed option)
Media set lever: �������������� Used to raise or lower the pinch rollers during the loading or unloading of media�
Pinch roller hold-down force switching lever:
���������������������������������������� Used to switch between the three pinch roller forces (outside push rollers only has
2 forces of strong and medium)�
AC line inlet: ������������������� Inlet where the power cord is connected�
Media stocker: ���������������� Used to carry roll media and ensure its proper rotation�
Stock rollers: ������������������� A media roll is placed on these rollers�
Media lock: ��������������������� Used to prevent the stock rollers from rotating when the media roll has been placed
on top of them� The media lock ensures that the media is pulled straight out from
the roll�
USB interface connector:
���������������������������������������� Used to connect the plotter to the computer with a USB interface cable�
Network interface connector:
���������������������������������������� Used to connect the plotter to the computer with a network interface cable�
(Factory-installed option)
RS-232C interface connector:
���������������������������������������� Used to connect the plotter to the computer with an RS-232 serial interface cable�
To Next Page
Loading...
