Deployment tasks run and software is uninstalled. Progress is reported and next
steps are indicated in both the Status and Details columns. If an error appears
regarding prerequisite software, install the prerequisite files on the control point
PC and then repeat this step.
6. When the Status or Details columns indicate next steps, identify the software in
the row, then do one of the following:
• For K2 software, when Details displays a Restart required link, click the link
and when prompted "...are you sure...", click Yes.
The K2 Media Server restarts. This restart is required by the K2 software
uninstall.
Deployment tasks run and software is installed. Progress is reported and next
steps are indicated in both the Status and Details columns.
7. When the Status or Details columns indicate next steps, identify the software in
the row, then do one of the following:
• For K2 software, when Details displays a Restart required link, click the link
and when prompted "...are you sure...", click Yes.
The K2 Media Server restarts. This restart is required by the K2 software install.
8. Monitor progress as indicated by both the Status and Details column. When finished,
the Status column indicates complete.
9. If you previously uninstalled SNFS manually because SNFS was on C:, copy
directories/files from C: to D:, overwriting files on D:, as follows.
a) Copy the C:\SNFS\config directory to D:\SNFS\config.
b) Copy the C:\SNFS\data directory to D:\SNFS\data. This directory can be large,
so allow adequate time to complete the copy operation.
c) A restart is required to put the change into effect. If you do a subsequent upgrade
task that also requires a restart, that restart is sufficient. Otherwise restart now.
d) After the entire K2 SAN upgrade process is complete, test media access. If
successful, delete the C:\SNFS directory and its files on the K2 Media Server.
34 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
