• The SiteConfig control point PC does not have a network drive mapped to an
administrative share (such as C$) on a device on which you are checking software.
• If the SiteConfig Network Configuration Kit and/or Discovery Agent at version
lower than 1.1.0.185 is currently installed, it must be manually uninstalled and
updated. For more information refer to SiteConfig Migration Instructions.
Do the following steps on the stand-alone K2 systems that you are upgrading.
1. In the Software Deployment | Deployment Groups tree view, right-click the top-most
node for the group or any individual device and select Check Software.
NOTE: If you have access problems, verify that the adminstrator account on
the device has credentials as currently configured in SiteConfig. By default
credentials on the device should be administrator/adminGV! for Aurora devices
and Administrator/adminK2 for K2 devices.
The Check Software dialog box appears. SiteConfig searches for software on
the selected device or devices and gathers information. Progress is reported.
2. When the check is complete for the selected device or devices, close the Check
Software dialog box.
An updated list of all currently installed software is displayed in the Software
Deployment | Devices | Installed Software list view. If software is a SiteConfig managed
software package, information is displayed in the Managed Package and Deployment
Group columns.
Related Links
About installing SiteConfig
Add software package to deployment group for stand-alone K2 systems
Prerequisites for this task are as follows:
• You can access the software package file or files from the SiteConfig control point
PC.
• The stand-alone K2 systems to which you are deploying software are in a
deployment group.
Use the following procedure to add one or more software packages to the deployment
group that contains your stand-alone K2 systems. For this release of K2 software,
identify and add software installation files as follows:
File nameSoftware
7.2.7.xxxx.cabK2 Client
software
SNFS software is bundled with the K2 software cab file.
1. In the Software Deployment | Deployment Groups tree view, select a deployment
group.
12 May 2010 K2 Version 7.2.7 Release Notes & Upgrade Instructions 51
Upgrading K2 systems
To Next Page
Loading...
