• If no message appears, the software uninstalls. Continue with the next step in
this procedure.
5. When prompted to restart, do not restart.
While a restart is required after installing K2 Client software, you can delay the
restart until after other tasks are complete.
6. On a K2 Summit Production Client or K2 Solo Media Server, disable the write
filter.
Disabling the write filter at this point keeps it disabled after the required restart.
This is helpful because it must be disabled in order to uninstall or install software,
which you will be doing after the restart.
7. Manage the required restart as follows:
• Restart now.
Related Links
Local software installation and the write filter on page 96
Uninstall SNFS from K2 client
Do not do this task if:
• SNFS version 3.5.2.b14727 is already installed and the installation (including
required restarts) is complete.
Do this task if:
• A SNFS version lower than 3.5.2.b14727 is currently installed
If you have not already done so, disable the write filter on the K2 Summit Production
Client or K2 Solo Media Server.
1. Make sure you are logged in with an administrator account.
2. Use the Windows Add/Remove Programs control panel and uninstall SNFS.
3. Disable the write filter.
Disabling the write filter at this point keeps it disabled after the required restart.
This is helpful because it must be disabled in order to install software, which
you will be doing after the restart.
4. Restart using the Windows operating system restart procedure.
Install K2 software
Prerequisites for this task are as follows:
• If you uninstalled the previous version of K2 software, you must restart the K2
client at least once before installing the new version of K2 software.
72 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
