Do not restart the K2 Summit Production Client or K2 Solo Media Server.
Install K2 Dyno Server software
If the K2 Dyno Server software was previously installed, you must uninstall the
software before you use these steps to install.
If you have not already done so, disable the write filter on the K2 Summit Production
Client or K2 Solo Media Server.
1. From the K2 Summit Production Client or K2 Solo Media Server, access the K2
Dyno Server software installation files.
2. In the Server directory, locate and open the following file:
setup.exe
3. Follow the onscreen instructions, and work through each page.
4. Click Next and Finish to complete the installation.
5. Restart the K2 Summit Production Client or K2 Solo Media Server.
On the K2 Summit Production Client or K2 Solo Media Server, in Configuration
Manager on the Ganging tab, make sure that Use a single channel to control the
gang or Record/play same clip on all channels of Gang is not selected.
Upgrade remaining stand-alone K2 systems
For stand-alone storage K2 systems, repeat the previous steps to upgrade your
remaining stand-alone storage K2 systems.
For the K2 Summit Production Client or K2 Solo Media Server, after you are done
with the upgrade process, enable the write filter.
Enable write filter
Prerequisite:
• K2 software must be installed on the K2 Summit Production Client or K2 Solo
Media Server
1. If you have not already done so, log on to the K2 Summit Production Client or K2
Solo Media Server with Windows administrator privileges.
2. From the Windows desktop, click Start | All Programs | Grass Valley | Write Filter
Utility.
FBWF Manager opens.
3. Under Filter Settings, set Filter to Enable.
4. Under Protected Volumes, set C: to Protected.
Do not modify other settings.
5. Click OK.
86 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
