Upgrade QuickTime
Do not do this task if:
• QuickTime is currently at version 7.6 or higher.
Do this task if:
• QuickTime is at a version lower than 7.6.
1. Access the QuickTime installation files.
2. Locate and open the following QuickTime install file:
QuickTimeInstaller-7.6.exe
3. Work through the install wizard.
Configure settings so that the software does not automatically update Quicktime
and other Apple software.
NOTE: Unless instructed to do so by Grass Valley, do not update or install
Apple software.
Accept the default destination folder and other default settings.
Configure SNFS default.cfg file on stand-alone K2 system
In this task you open the media file system (SNFS) configuration file and verify/modify
settings.
Do not do this task if one of the following is true:
• You have already modified the configuration file with the required settings.
• The K2 system was installed new with the following K2 software version:
• A 7.x version higher than 7.0.11
At this version the required settings are preconfigured.
• A K2 Solo Media Server
Do this task if:
• You are upgrading from a current version of K2 software as follows:
• Version 7.0.11
Prerequisites for this task are as follows:
• K2 systems must be offline
You can verify and, if necessary, modify the media file system (SNFS) configuration
file and still keep your media file system intact if you carefully follow the steps in this
procedure.
70 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
