[StripeGroup VStripe]
.
.
.
Rtios 250
.
6. Do one of the following:
• If you modified the configuration file, click Modify and when prompted
"...restarted now" click OK. The K2 system restarts.
• If you did not modify the configuration file, click Cancel and then exit Storage
Utility. When prompted "...back to online mode?" click Yes.
Reset Capture Services
Do not do this task if:
• You do not use any of the K2 Capture Services.
Do this task if:
• You are using one or more K2 Capture Services, such as the following:
• HotBin service
• Pathfire capture service
• DG capture service
• XML Import capture service
• P2 Import capture service
Do this task on the K2 system running your K2 Capture Service, which is the K2
system that receives the media to be imported into K2 storage. This can be a K2 Solo
Media Server, a stand-alone K2 Summit Production Client, or the K2 Media Server
with the role of primary FTP server on a K2 SAN.
When you configure a K2 Capture Service for the first time, the service is set to startup
type Automatic. However, if you upgrade or otherwise re-install your K2 System
Software, the service is re-set to startup type Manual. Therefore, you must re-configure
the service after K2 System Software upgrade/ reinstall in order to set the startup type
back to Automatic.
1. From the Start menu, access the Programs menu and select Grass Valley | K2 Capture
Services.
On a K2 Summit/Solo system, if the write filter is enabled, a message appears
that informs you about the write filter and prompts you to restart. Restart as
prompted, then repeat this step.
The K2 Capture Services utility dialog box is displayed.
2. Click Apply.
12 May 2010 K2 Version 7.2.7 Release Notes & Upgrade Instructions 63
Upgrading K2 systems
To Next Page
Loading...
