Upgrade MegaRAID Storage Manager
Do not do this task if:
• A K2 Solo Media Server
• A K2 Summit Production Client with direct-connect storage
• A K2 Summit Production Client installed new with K2 software version 7.1.x or
higher, in which case MegaRAID Storage Manager is pre-installed at version
2.91-05.
• A K2 Summit Production Client with MegaRAID Storage Manager already
upgraded to version 2.91-05.
Do this task if:
• A K2 Summit Production Client with internal storage and with the MegaRAID
Storage Manager at a version lower than 2.91-05.
1. If you are not sure of the MegaRAID Storage Manager version currently installed,
open Windows Add/Remove Programs Control Panel and identify the version.
Continue if the upgrade is necessary.
2. Access the installation file at ..\Drivers\MegaRAID29105\DISK1\ and double-click
setup.exe.
An install wizard opens.
3. Work through wizard pages, accepting defaults.
4. When prompted, select Custom Installation and click Next.
5. Select the StandAlone option and click Next.
6. Click Install.
7. When prompted "...continue?" click Yes.
The software installs.
Upgrade RAID Controller microcode on stand-alone K2 system
Do not do this task if one of the following is true:
• A K2 Solo Media Server
• A K2 Summit Production Client installed new with K2 software version 7.1.x or
higher, in which case a compatible version of RAID controller microcode is
pre-installed.
• A K2 Summit Production Client with internal storage and with RAID controller
microcode already upgraded to a compatible version, as listed in compatibility
specifications.
• A K2 Summit Production Client with direct-connect storage and with RAID
controller and/or expansion chassis microcode already at compatible versions, as
listed in compatibility specifications.
Do this task if:
78 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
