GRASS VALLEY K2 - Upgrade LSI RAID Controller Driver

4. Restart as prompted.
Upgrade LSI RAID controller driver
Do not do this task if:
• A K2 Solo Media Server
• A K2 Summit Production Client with direct-connect storage
• A K2 Summit Production Client installed new with K2 software version 7.1.x or
higher, in which case the driver is pre-installed at version 3.10.0.32.
• A K2 Summit Production Client with the driver already upgraded to version
3.10.0.32.
Do this task if:
• A K2 Summit Production Client with internal storage and a driver at a version
lower than 3.10.0.32.
1. If you are not sure of the driver version currently installed, do the following:
a) open Windows Device Manager | SCSI and RAID controllers | LSI MegaRAID SAS
PCI Express ROMB | Properties | Driver.
b) Check file properties. The following properties indicate that version 3.10.0.32
is already installed:
Date
Version
7/22/20093.10.0.32
c) If the upgrade is necessary, continue with this procedure.
2. Open Windows Device Manager | SCSI and RAID controllers.
3. Right-click LSI MegaRAID SAS PCI Express ROMB and select Update driver.
An install wizard opens.
4. Select No, not this time and click Next.
5. Select Install from a list or specific location [Advanced] and click Next.
6. Select Don't search. I will choose the driver to install and click Next.
7. Click Have disk.
8. Click Browse, navigate to the LSI_1078_winxp directory, select oemsetup.inf,
and click OK.
9. Click Next.
10. When prompted regarding Windows Logo Compatibility, select Continue Anyway
and click Finish.
11. Restart as prompted.
12 May 2010 K2 Version 7.2.7 Release Notes & Upgrade Instructions 77
Upgrading K2 systems