GRASS VALLEY K2 - Upgrade Megaraid Storage Manager

c) If the upgrade is necessary, continue with this procedure.
2. Open Windows Device Manager | SCSI and RAID controllers.
3. Right-click LSI MegaRAID SAS PCI Express ROMB and select Update driver.
An install wizard opens.
4. Select No, not this time and click Next.
5. Select Install from a list or specific location [Advanced] and click Next.
6. Select Don't search. I will choose the driver to install and click Next.
7. Click Have disk.
8. Click Browse, navigate to the LSI_1078_winxp directory, select oemsetup.inf,
and click OK.
9. Click Next.
10. When prompted regarding Windows Logo Compatibility, select Continue Anyway
and click Finish.
11. Restart as prompted.
Upgrade MegaRAID Storage Manager
Do not do this task if:
• A K2 Solo Media Server
• A K2 Summit Production Client with direct-connect storage
• A K2 Summit Production Client installed new with K2 software version 7.1.x or
higher, in which case MegaRAID Storage Manager is pre-installed at version
2.91-05.
• A K2 Summit Production Client with MegaRAID Storage Manager already
upgraded to version 2.91-05.
Do this task if:
• A K2 Summit Production Client with internal storage and with the MegaRAID
Storage Manager at a version lower than 2.91-05.
1. If you are not sure of the MegaRAID Storage Manager version currently installed,
open Windows Add/Remove Programs Control Panel and identify the version.
Continue if the upgrade is necessary.
2. Access the installation file at ..\Drivers\MegaRAID29105\DISK1\ and double-click
setup.exe.
An install wizard opens.
3. Work through wizard pages, accepting defaults.
4. When prompted, select Custom Installation and click Next.
5. Select the StandAlone option and click Next.
6. Click Install.
7. When prompted "...continue?" click Yes.
12 May 2010 K2 Version 7.2.7 Release Notes & Upgrade Instructions 57
Upgrading K2 systems