The K2 Dyno Client software closes and the Windows OS desktop is
displayed after a restart.
2. Use the Windows Add/Remove Programs control panel and remove K2 Dyno Client
software.
Install software on K2 Dyno Controller
You must uninstall K2 Dyno Client software before you use these steps to install K2
Dyno Client software.
1. Copy the directory that contains the K2 Dyno Client software onto a portable USB
drive, such as a Flash drive.
2. Connect the USB drive to the K2 Dyno Controller and copy the Client directory
to the K2 Dyno Controller desktop.
3. In the Client directory, locate and open the following file:
setup.exe
4. Follow the onscreen instructions, and work through each page.
• If this is the first install after a re-image, enter the K2 Dyno Replay Controller
serial number when prompted.
• If the K2 Dyno System Configuration Tool opens, do not enter any information.
Remove any text from the serial number field, as it must be blank. Then click
OK and when prompted "...number is empty. Continue?", click OK.
• If prompted "...update to new firmware?" click Yes, observe progress on the
K2 Dyno Controller Firmware Updater, and when a Success message displays,
click OK.
5. Click Next and Close to complete the installation.
6. Remove the portable USB drive, if it is still connected.
7. Restart using standard Windows procedures.
8. When prompted "...back to K2 Dyno mode...?", click Yes.
The K2 Dyno Controller restarts.
Install MPEG-2/AVC-Intra field kit
If you are installing an MPEG-2 or AVC-Intra field kit upgrade on one or more or
your K2 Summit Production Clients or K2 Solo Media Servers, do so now. Follow
the procedure in the Field Kit Upgrade Instructions document that you received
with the field kit.
88 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
