Click Finish on the Hardware Update Wizard to continue installation. If
multiple Hardware Update Wizards open, finish them similarly.
9. Click Next and Finish to complete the installation.
10. When prompted to restart, proceed as follows:
• Disable the write filter.
Disabling the write filter before the restart keeps it disabled after restart. This
is helpful because it must be disabled in order to install software, which you
will be doing after the restart.
• Do one of the following:
• If the version from which you are upgrading is lower than 7.1.0.1153, shut
down the system. After the system is shut down, press the standby button
to power up the system. You must shutdown/powerup (power cycle), rather
than restart.
• If the version from which you are upgrading is 7.1.0.1153 or higher, restart.
Related Links
Local software installation and the write filter on page 96
Install SNFS on stand-alone K2 system
Prerequisites for this task are as follows:
• Before installing a new version of SNFS software, make sure that the computer
has been restarted at least once since the previous version of SNFS software was
uninstalled.
1. Access the SNFS installation files.
2. Expand SNFS_3.5.2_14727.exe
3. Run gvSnfs352SetupSummit.bat
The command window appears. After a pause, messages confirm setup complete.
4. Press any key to proceed.
5. Restart media file system services as follows:
a) Click Start | Programs | SNFS File System | Services Stop.
b) Click Start | Programs | SNFS File System | Services Start.
6. Restart the computer using the Windows operating system restart procedure.
Verify upgraded software
When the K2 client starts up, you can verify that the correct versions of software are
installed as follows:
12 May 2010 K2 Version 7.2.7 Release Notes & Upgrade Instructions 75
Upgrading K2 systems
To Next Page
Loading...
