NOTE: If there are dependencies, SiteConfig can enforce that some tasks be
deployed together.
4. Check the area next to the Start Deployment button for a message.
If a message instructs you to upgrade the Discovery Agent, on the control point
PC go to the directory to which SiteConfig is installed, find the
DiscoveryAgent_x.x.x.x.cab file, add it to the deployment group, and deploy
the Discovery Agent software as well.
5. Click the Start Deployment button.
Deployment tasks run and software is uninstalled. Progress is reported and next
steps are indicated in both the Status and Details columns. If an error appears
regarding prerequisite software, install the prerequisite files on the control point
PC and then repeat this step.
If upgrading both K2 and SNFS software, SiteConfig uninstalls both in the
proper sequence.
6. When the Status or Details columns indicate next steps, identify the software in
the row, then do one of the following:
• For SNFS software, when Details displays a Restart required link, click the link
and when prompted "...are you sure...", click Yes. After this restart, continue
with other restarts as indicated.
• For K2 software, if the version from which you are upgrading is lower than
7.1.0.1153, do not restart. Do not click the Restart required link displayed in
Details. Instead, you must power cycle the K2 system, as instructed in the next
task.
• For K2 software, if the version from which you are upgrading is 7.1.0.1153 or
higher, when Details displays a Restart required link, click the link and when
prompted "...are you sure...", click Yes.
54 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
