L-SOLUTION 700 / 800 / 900 machines . 68
First contact
Start engraving.
Stop temporarily engraving.
Access differents menus, menu exit, move to the next screen or to the next
menus (for sequential menus), settings recorded.
Access menu exit without saving last setting, return to reception when pause
(during engraving), end of reception, end of engraving.
Activate a LASER beam (red diode LASER) which permits to see the
head position on the plate.
Adjust manual focus (manual Z Ref.).
Allow to carry out an Autofocus (automatic ZRef.) at any time.
XY, Z head travel, selecting or adjusting a setting.
Activate the air assist when engraving.
To cut off the mains supply to the machine in case of severe problems,
switch off the machine with the main stop button.
Display the following file stocked in the machine memory. This becomes
the current file.
START
ENGRAVING START
PAUSE
VALIDATION
CANCEL
AIR
ASSIST
FOCUS
ADJUSTMENT
AUTOFOCUS
JOYSTICK
MAIN STOP
BUTTON
FILE
SELECTION
POSITIONING
RED DIODE
Validation
Air assist
File selection
Cancel
Autofocus
Positioning red diode
Start
Engraving start
Pause
Focus adjustment
Joystick
Indicator
lights
System operation
To Next Page
Loading...
