Communication
8-36 Chapter 8
SERIAL PORT
The Ethernet interface module will be connected to either comm port 3 or 4. The corresponding comm port
settings need to be 19,200 baud/ 8 data bits/ 1 stop bits and Xon flow control. Refer to the Ethernet
interface module instructions manual for further details on setup and configuration.
GSE W
EB
S
ERVER
GSE has developed a web server, which is resident within the flash memory of the Ethernet option module.
Refer to the Ethernet Interface Module Instructions for details on accessing and using the GSE Web Server.
T
ELNET
C
LIENT
/S
ERVER
The Ethernet Option module can act as both a Telnet Server and a Client at the same time. However, only
one connection can be present at one time. Refer to Ethernet Interface Module Instructions for details on
configuring and using a telnet connection.
FTP C
LIENT
Both active and passive modes are supported. It is necessary to use macros and custom transmits to
communicate to a FTP server. Refer to Ethernet Interface Module Instructions for details on configuring the
FTP server.
M
ODBUS
TCP/IP S
LAVE
(S
ERVER
)
Only one connection to the Ethernet option module from a Client can be made at once. Refer to Ethernet
Interface Module Instructions for details on setup and configuration
To Next Page
Loading...
