GSE 672 - Perform Sample

Model 672/675 Technical Reference Manual
9-81
%accuracy Target accuracy percentage (90 → 99.96; 0 = Not Enforced).
Notes
The %accuracy argument does not change the setup mode selection at P183, rather it
temporarily changes the accuracy requirement until power is interrupted or upon saving
changes when exiting the setup mode.
A %accuracy less than 90 eliminates the accuracy requirement.
See Also
%b Perform Sample
%g Sample / Macro Error
If Target Accuracy Achieved
%a
Determines if the last sample was large enough to meet the accuracy requirement set at P183. This
command can be used to ensure an accurate sample before proceeding with other macro routines (see
example - Checking for Sample Accuracy).
Set Target Accuracy
< %accuracy > %a
Override the power-up accuracy selection at P183.
Get Target Accuracy
?%a
Copies the current accuracy requirement to the entry buffer where it can be saved to a parameter and/or
used in math commands.
Restore Default Accuracy
*%a
Restores the accuracy requirement to the value set at P183.
%
%
b
b
P
P
e
e
r
r
f
f
o
o
r
r
m
m
S
S
a
a
m
m
p
p
l
l
e
e
Syntax Perform Sample
%b
See Also
%a Target Accuracy
%g Sample / Macro Error
Sampling to Establish The Piece Weight
Perform Sample
Suspends macro execution and performs the sample routine. The quantity mode is selected automatically
and a tare is performed. The display then prompts for the default sample size and the standard sample
routine continues.
Once the sample routine is completed, macro execution resumes with the next instruction after the %b
command. Pressing [CLR] will completes the sample routine by aborting the sample process.
99.48%a Sets the target accuracy requirement to 99.48%.
99.92%a Sets the target accuracy requirement to 99.92%.
0%a Eliminates the accuracy requirement.