Application Setup
Chapter 3
3-10
1. From the time/date tab, press [F1] to access the configuration screen. The time can be changed with the
[F1] key. The date can be changed with the [F2] key.
2. Key in the time or date by following the format on the display and press [ENTER] to accept the entry.
3. Press [F5] (EXIT) to return to the main menu.
Setup (Setup Mode Access)
This tab allows access to the setup mode to make changes to parameters such as full scale, count accuracy
and baud rate etc. Refer to the following chapters for details on more advanced setups and configurations.
See page 3-39 for explanation of each parameter.
Access the setup mode:
1. From the Setup tab press [F1].
2. Key in the access code 23640 (factory default code) and press [ENTER]. P108 will be displayed.
NOTE: If a pin number has been entered at P400 that is the access code. Make sure not to forget the pin
number.
Apps (Applications)
Access the Application Menu to switch to another operating mode or the factory default mode.
1. From the Apps tab press [F1].
2. Key in the access code and press [ENTER]. The Apps Menu will automatically load.
NOTE: Press [F5] at any time to abort loading the Apps Menu.
F3 – GSE D
EFAULT
If the preprogrammed applications are not going to be used, than the Model 672 should be factory defaulted.
This mode will reset the Model 672 to GSE factory default status. The preset applications will be lost but can
be reestablished at parameter 65002 (See page 10-15 for more details).
The Model 672 can still be used as a parts counter after it is factory defaulted. Refer to page 4-7 for details
on simple counting.
SETUP THE GSE DEFAULT MODE
1. Press [F3] from the APPLICATION MENU prompt. The display will give an explanation of the GSE
DEFAULT.
2. Press [ENTER] (YES) to accept the choice of GSE DEFAULT and continue or press [CLR] to cancel the
default and return to the APPLICATION MENU.
3. If you chose to continue with the default in step 2 the display will ask “ARE YOU SURE?” Either press
[ENTER] (YES) to default the unit or press [CLR] to cancel the default and return to the APPLICATION
MENU.
4. The display will blank out and load the GSE Default mode.
To Next Page
Loading...
