Service Manual for the Accutherm Ultra Printer TOC-iii
Remove the Print Head Assembly from the Printer
Mechanism Assembly (Lower Print Mechanism) ..7-11
Remove the Rotary Knife from the Printer
Mechanism Assembly (Lower Print Mechanism) ..7-13
Remove Paper Path Assembly from Printer
Mechanism..............................................................7-14
Remove Stacker Guide Assembly from the
Printer Mechanism Assembly.................................7-18
Remove Platen from the Knife/Stacker Assembly...7-20
Remove Fixed Blade from the Knife/Stacker
Assembly.................................................................7-21
Chapter 8
Troubleshooting
Introduction to Troubleshooting.................................8-1
Troubleshooting Steps for FST’s ...............................8-2
Troubleshooting Steps for RLT’s...............................8-5
Loading Paper ............................................................8-9
Clearing a Paper Jam................................................8-11
Chapter 9
Preventive Maintenance
General Cleaning........................................................9-1
Cleaning the Print Head .............................................9-2
Cleaning the Top-of-Form/ Paper Low Sensor..........9-3
Cleaning the Jam Detection Sensor............................9-4
Cleaning the Platen.....................................................9-4
To Next Page
Loading...