GW Instek ASR-2000 Series - [:Source]:Simulation:initial:phase:start:ena Ble; [:Source]:Simulation:initial:phase:start[:IMM Ediate]

REMOTE CONTROL
99
Example
:SIM:INIT:FREQ 60
Sets the frequency of the initial step to 60Hz.
[:SOURce]:SIMulation:INITial:PHASe:STARt
:ENABle
Set
Query
Description
Enables/Disables (Fixed/Free) the ON Phs
parameter of the initial step for the Simulation mode.
Syntax
[:SOURce]:SIMulation:INITial:PHASe:STARt:ENABle
{<bool>|OFF|ON|FREE|FIXED}
Query Syntax
[:SOURce]:SIMulation:INITial:PHASe:STARt:ENABle?
Parameter/Return
parameter
OFF | 0 |
FREE
Disabled
ON | 1 |
FIXED
Enabled
Example
:SIM:INIT:PHAS:STAR:ENAB 1
Enable the ON Phs.
[:SOURce]:SIMulation:INITial:PHASe:STARt
[:IMMediate]
Set
Query
Description
Sets or queries the ON Phs parameter of the initial
step for the Simulation mode.
Syntax
[:SOURce]:SIMulation:INITial:PHASe:STARt
[:IMMediate] {<NR2>|MINimum|MAXimum}
Query Syntax
[:SOURce]:SIMulation:INITial:PHASe:STARt
[:IMMediate]? [MINimum|MAXimum]
Parameter/Return
parameter
<NR2>
ON Phs (start phase)
MINimum
0
MAXimum
359.9
Example
:SIM:INIT:PHAS:STAR 0
Sets ON Phs to 0.