GW Instek ASR-2000 Series User Manual

APPENDIX
201
Sensing Voltage Error
Remote sense connection wire is
abnormal or over maximum
compensation voltage. Press
"Shift + Cancel" to clear this
alarm.
Output Off
Startup Anomaly
Abnormal startup procedure.
Contact service center.
System Lock
External Sync
Frequency Error
The external synchronization
signal input frequency is out of the
allowance range. (40Hz ~
999.9Hz)
Output Off
SCPI Error
Communication with the SCPI
command error
Display Message
Only
Power ON Fail
Power ON Function Fail In Error
Mode or Range
IRMS Limit
The RMS current limiter is
activated. Press "Irms" to check
allowance set range
IPK Limit
The peak current limiter is
activated. Press " Shift + Irms" to
check allowance set range
Remote Sensing
Voltage Out of Range
The Sensing voltage limiter is
activated.
Display Message
Only
System Error (#)
System Error (1~15). Contact
service center.
Display Message
Only
Power Limit
The Power limiter is activated
Web Data Error
This message will only be shown
when texio update file is used and
firmware is selected gw.
Note
The system would be locked or output off automatically
before the error state is cleared.
Normal Messages
Description
Protection type
Setting Voltage Limited
Setting voltage be limited, press
"Shift + V" to check allowance set
range
Display Message
Only
Setting Frequency
Limited
Setting frequency be limited,
press "Shift + F" to check
allowance set range
Display Message
Only

GW Instek ASR-2000 Series Specifications

General

Brand	GW Instek
Model	ASR-2000 Series
Category	Portable Generator
Language	English