GW Instek ASR-2000 Series - Turning the Output On;Off

OPERATION
99
Turning the Output On/Off
When the output is turned on, the DUT can be connected to either
the rear panel output or the front panel output.
WARNING
Both of these outputs are electrically linked. Only one
DUT should be connected to any one of the outputs at
a time. Using both outputs at the same time is not
supported. Using the front and rear outputs at the
same time could cause dangerous operating
conditions. See page 37 for details about using the
output terminals or sockets.
Turn Output On
Press the Output key. The Output key
will light up in orange and ON will be
displayed in the status bar to indicate
that the output is on.
Turn Output Off
Press the Output key. The Output key
light will go out and OFF will be
displayed in the status bar to indicate
that the output is off.